How do I make a look up and make a snap shot?

  • 38
  • 1
  • Question
  • Updated 1 week ago
  • In Progress
I have a est end date field that I want to be able to save the original thing entered in the field but allow the original est end date field to be changed. How do I do this? and I do not know how to make a look up or make a snap shot.
Photo of Nate McKinney

Nate McKinney

  • 304 Points 250 badge 2x thumb

Posted 2 weeks ago

  • 38
  • 1
Photo of Evan Martinez

Evan Martinez, Community Manager

  • 9,264 Points 5k badge 2x thumb
Hi Nate,

Is this estimated end date already a look up field coming down from another table or is it that all on one table you would like to have the Estimated End date in a field and if it is changed you want it written into another field on that same table? If so you could create a Historical End Date field that is meant to capture the original Est End Date and set up an Automation so that when the record is first created the Est End Date is also copied over into the Historical End Date. This way the est end date field can change over and over but the original value first added will stay recorded. It largely depends on how you want to capture the information, as if it is just the very first original end date you want to capture or all the changes, etc. 
(Edited)
Photo of David Brogdon

David Brogdon

  • 582 Points 500 badge 2x thumb
There are a multitude of ways to accomplish this. 


1) You can just create two fields, 1 for Original EED, 1 for edited EED. Set a form rule that says, "If [Original EED] is not blank, make [Original EED] read-only.

2) You can create an [EED] field, and then create another field called [EED Snapshot]. Open the [EED Snapshot] field and under the settings, near the bottom there is a field that says "Snapshot: Get this field's value from another field and don't allow it to change." click that and select the [EED] field as the source for the value. Make sure to initialize fields if applicable.

3) Create two fields, say [EED] and  [EED Snapshot], create a form rule that says "When [EED Snapshot] is blank and When [EED] is not blank, change [EED Snapshot] to the value in the field [EED]. Keep the "fire on change.." checkbox checked. 

4) several ways to automate as mentioned already.


I recommend using the native snapshot functionality whenever possible, or hard coding it as in example #1
(Edited)