Forum Discussion

EricRovner's avatar
EricRovner
Qrew Member
5 months ago

Dynamic Form Rule

Hello, I'm hoping someone smarter than me can help! I am using Dynamic Form Rules to adjust the fields that show on a form. Here's a simplified example of what I am trying to do but can't figure out how to set up without triggering the Form Rules warning about 'show/hide rules' on the same field;

  • If the field Part is set as "Tire", hide the field Interior
  • If the field Part is set as "Wheel", hide the fields Interior and Consumable
  • If the field Part is set as "Reflector", hide the fields Interior, Consumable, and Replaceable
  • If the field Part is set as "Paint", hide the fields Interior, Consumable, Replaceable, and Size

Thanks in advance for your counsel!



------------------------------
Eric Rovner
------------------------------

2 Replies

Sort By
  • MarkShnier__You's avatar
    MarkShnier__You
    Qrew Champion
    5 months ago

    This thread here has a somewhat tongue in cheek discussion. Basically you need a rule per field and not a rule per situation.



    ------------------------------
    Mark Shnier (Your Quickbase Coach)
    mark.shnier@gmail.com
    ------------------------------
    • EricRovner's avatar
      EricRovner
      Qrew Member
      5 months ago

      Thanks as always Mark! Yep, the discussion was indeed tongue in cheek but this was exactly what was needed in this case! I mumbled a bit, went back the basics with pencil and paper, and just finished putting the Dynamic Form Rules into their place!



      ------------------------------
      Eric Rovner
      ------------------------------