dynamic form rules and or

Hey Coach - how would you implement dynamic rule on workflow that is sequential. The workflow was 5 stages in total but not all steps needs to be completed i,e, some work can have only 3, 4 or 5 stages. For simplicity each workflow is on its own TAB. 

Here is what i would like to be with getting this error "(Rules #3 and #4 are both 'show/hide' rules on the same tab (Reviewer 2)" 

If the total # of workflow stage is 3, than show TAB 1-3
IF the total # of workflow Stage is 4 then show TAB 1- 4
If the total # of workflow stage is 5, then show TAB 1-5

Note I have a formula field that calculates the total stage.

Thanks

Your rules conflict/overlap.
Show tab 1.
Show tab 2.
Show tab 3.
If the total # of workflow stage >3, show tab 4, otherwise hide it.
If the total # of workflow stage >4, show tab 5, otherwise hide it.

In the movie "Cool Hand Luke" the warden has him digging and hole and and filling it in again and again to get Paul Neuman to "get his mind right"

  https://www.youtube.com/watch?v=8CBqjZX6FjE at 0:30 seconds in.

So we just need you to get your mind right.

1. Scrap your existing form rules.

2. Take out a single blank piece of paper.  Write down the rules for when to show Tab 1.  Put down your pen.

3. Hands on Keyboard. Make a Dynamic form rule to just do THAT.

4. Take out another single blank piece of paper.  Write down the rules for when to show Tab 2.  Put down your pen.

5. Hands on Keyboard.  Make a Dynamic Form Rule to just do that.
 
6. Take out another single blank piece of paper.  Write down the rules for when to show Tab 3.  Put down your pen.

7. Hands on Keyboard.  Make a Dynamic Form Rule to just do that.

8. Take out another single blank piece of paper.  Write down the rules for when to show Tab 4.  Put down your pen.

9. Hands on Keyboard.  Make a Dynamic Form Rule to just do that.

Now, "Get you mind right" and get digging.

Thanks