Forum Discussion
JordanMcAliste1
Qrew Member
I think your automation would be when a "Part" is edited (in this case, checked) AND "Parts Oustanding" = 0, THEN change the PO status. So, if you had 5 parts, the automation would run when the last part has been checked off as received because at that point the parts outstanding value would be zero by the time the automation ran.
------------------------------
Jordan McAlister
------------------------------
------------------------------
Jordan McAlister
------------------------------
MatthewWitzgall
4 years agoQrew Member
I tried this, and it did not work.
------------------------------
Matthew Witzgall
------------------------------
------------------------------
Matthew Witzgall
------------------------------
- MarkShnier__You4 years agoQrew ChampionDid you make use of the summary fields being looked up down to the child line items in your trigger?
------------------------------
Mark Shnier (YQC)
Quick Base Solution Provider
Your Quick Base Coach
http://QuickBaseCoach.com
mark.shnier@gmail.com
------------------------------- MatthewWitzgall4 years agoQrew MemberYes. Still no luck.
------------------------------
Matthew Witzgall
------------------------------- MarkShnier__You4 years agoQrew ChampionCan you post a screen shot of the trigger for your Automation including to "open" the section or the filter?
------------------------------
Mark Shnier (YQC)
Quick Base Solution Provider
Your Quick Base Coach
http://QuickBaseCoach.com
mark.shnier@gmail.com
------------------------------