URL to manually refresh a connected table
Is anyone aware of method for non-admin to manually refresh a connected (gmail) table? I have a gmail connected table with minimum refresh time (one hour). Sometimes we are aware of an email from c...
Forum Discussion
You can initiate the refresh with a url similar to this:
https://mydomain.quickbase.com/qb/sync/refreshTasks?replicationID=12345
The trick is knowing your replication ID. You will need, as the admin, monitor your network traffic during a manual refresh, and pull out the ReplicationID.
Then you should be able to add a button for everybody to refresh the data.
https://mydomain.quickbase.com/qb/sync/refreshTasks?replicationID=12345
The trick is knowing your replication ID. You will need, as the admin, monitor your network traffic during a manual refresh, and pull out the ReplicationID.
Then you should be able to add a button for everybody to refresh the data.
- Hi Matthew,
A very good alternative approach.
This Approach does not show the errors .--> as its a button.
If I want to show the errors to Non-Admin users, Is there a way to show errors after the Sync run.
------------------------------
Vivek Vishwanath
Hyderabad, India
+91 8185868789
------------------------------ - Is anyone aware of a good way to configure this in a webhook, as QB is phasing out JS?
------------------------------
E. P.
------------------------------- For webhook please see my response at this post:
https://community.quickbase.com/communities/community-home/digestviewer/viewthread?MessageKey=aeaf08cb-3f79-4d60-a5ea-540b2015222c&CommunityKey=d860b0f8-6a48-487b-b346-44c47a19a804&tab=digestviewer
Thank you
------------------------------
Razi D.
Desta Tech LLC
razi@destatechs.com
------------------------------
