Forum Discussion
MCFNeil
Qrew Captain
You can initiate the refresh with a url similar to this:
https://mydomain.quickbase.com/qb/sync/refreshTasks?replicationID=12345
The trick is knowing your replication ID. You will need, as the admin, monitor your network traffic during a manual refresh, and pull out the ReplicationID.
Then you should be able to add a button for everybody to refresh the data.
https://mydomain.quickbase.com/qb/sync/refreshTasks?replicationID=12345
The trick is knowing your replication ID. You will need, as the admin, monitor your network traffic during a manual refresh, and pull out the ReplicationID.
Then you should be able to add a button for everybody to refresh the data.
VivekVishwanat2
4 years agoQrew Cadet
Hi Matthew,
A very good alternative approach.
This Approach does not show the errors .--> as its a button.
If I want to show the errors to Non-Admin users, Is there a way to show errors after the Sync run.
------------------------------
Vivek Vishwanath
Hyderabad, India
+91 8185868789
------------------------------
A very good alternative approach.
This Approach does not show the errors .--> as its a button.
If I want to show the errors to Non-Admin users, Is there a way to show errors after the Sync run.
------------------------------
Vivek Vishwanath
Hyderabad, India
+91 8185868789
------------------------------